You are here
California Bearing Ratio
The California Bearing Ratio (CBR) test is a simple strength test that compares the bearing capacity of a material with that of a well-graded crushed stone (thus, a high quality crushed stone material should have a CBR @ 100%).
The CBR rating was developed for measuring the load-bearing capacity of soils used for building roads. The CBR can also be used for measuring the load-bearing capacity of unimproved airstrips or for soils under paved airstrips. The harder the surface, the higher the CBR rating. A CBR of 3 equates to tilled farmland, a CBR of 4.75 equates to turf or moist clay, while moist sand may have a CBR of 10. High quality crushed rock has a CBR over 80. The standard material for this test is crushed California limestone which has a value of 100.
CBR (%) = ( x / y ) x 100
where:
x = material resistance or the unit load on the piston (pressure)
for 2.54 mm (0.1") or 5.08 mm (0.2") of penetration
y = standard unit load (pressure) for well graded crushed stone
= for 2.54 mm (0.1") penetration = 6.9 MPa (1000 psi)
= for 5.08 mm (0.2") penetration = 10.3 MPa (1500 psi)
Disclaimer; This wiki article is contributed by our members without formal peer review and should not be taken as legal or contractual advice. All information read here is without any implied warranty of fitness for any purpose or use whatsoever. Even articles that have been vetted by informal review may later have been edited inappropriately, just before you view them.